Upgraded Talaria 220mm Brake Rotor
Upgraded Talaria 220mm Brake Rotor
Couldn't load pickup availability
Share
Upgraded 220mm x 2.3mm Brake Rotor for Talaria XXX MX3 MX4
Engineered with a flame pattern to increase airflow and heat dissipation. 2.3mm Thickness allows use of stock calipers, MTB calipers, or Moto Brake Calipers.
- Made From 12CR13 Stainless Steel
- Fits: Talaria XXX, MX3, MX4
- 220mm Diameter for increased braking power
- 2.3mm thickness for maximum heat dissipation and compatibility across many kinds of brake calipers
- Rear Bolt Pattern for Talaria Rotor ( 68mm )
- Front Bolt Pattern for Talaria, or most Emoto front rotors ( 44mm )
Install Steps:
- Remove your wheel
- Lightly heat your bolts holding on the stock rotor ( to break the locktite loose )
- Remove your stock rotor bolts, then slip the rotor off
- Apply a thin layer of Blue Locktite ( or similar thread locker )
- Slip on the new rotor and tighten the bolts down by hand
- Use a torque wrench to torque each bolt to desired spec
- Re-install your wheel
- DO NOT FORGET to install new Brake Pads & Slowly Bed in your new pads and rotor!
FAQ:
Q: Does this fit the Talaria MX5?
A: No this rotor is only made to fit the Talaria XXX, MX3, MX4
Q: Does this rotor work with FactoryZ Moto Brakes?
A: No our moto brake bracket is made to use our 240MM Rotors, running a 220 rotor will cause the pads to not have enough contact.
Ships from USA!
Please be aware that many electric bikes sold by RegenRides, its partners, and wholesalers are intended exclusively for off-road use at their speed and power factory setting. Bypassing or modifying the bike restrictions does not adhere to proper use and as the owner, you will assume full responsibility and liability. It is important to acknowledge that these vehicles may not adhere to specific national, federal, provincial, and/or local laws or regulations.
As the buyer, it is your responsibility to thoroughly acquaint yourself with any potential restrictions that may apply to the usage of such a product in your specific location. You assume complete liability for the choices you make regarding its utilization and any potential ramifications that may arise as a result.
This vehicle is not an "electric assisted bicycle" as defined by North Carolina Motor Vehicle Code and is instead a type of motor vehicle and subject to applicable motor vehicle laws if used on public roads or public lands. Your insurance policies may not provide coverage for accidents involving the use of this vehicle. To determine if coverage is provided you should contact your insurance company or agent.