1 2

M10 x 1.25 Titanium Banjo Bolt – Grade 5 ( 2 pack )

M10 x 1.25 Titanium Banjo Bolt – Grade 5 ( 2 pack )

$43.99 USD
$43.99 USD
Sale Sold out

Shave grams, add strength, and forget about rust. This Grade 5 titanium banjo bolt in M10 × 1.25 pitch drops straight into dirt-bike or street-bike calipers and master cylinders, sealing brake fluid with a factory-fresh look. It’s pre-drilled for safety wire and ships with fresh copper crush washers, so you can torque, ride, and show off that titanium bling the moment the box lands.

Features

  • Pure Grade 5 titanium—about 45 percent lighter than steel and completely corrosion-proof

  • Exact M10 × 1.25 mm thread for coarse-pitch Nissin, Honda, Yamaha, Surron, Talaria, and more

  • Safety-wire holes ready for race-day tech inspection

  • Copper crush washers included for a leak-free seal

  • Single-banjo design keeps the fluid path compact and clean

Specs

  • Thread size: M10 × 1.25

  • Total length: 25 mm

  • Thread length: 10 mm

  • Head height: 5.8 mm

  • Bolt weight: 6.6 g

  • Washer weight: 1 g each

  • Material: Ti-6Al-4V (Grade 5)

Bike Compatibility

  • Surron Ultra Bee and Light Bee moto brake systems

  • Talaria MX3, MX4, and XXX moto brake systems

  • E-Ride Pro SS moto brake systems

  • Honda CRF and CBR models (coarse thread)

  • Yamaha YZ and R-series, Kawasaki KX and ZX, plus any caliper or master cylinder that uses M10 × 1.25 threads

Install Guide

  1. Remove the old bolt and washers, catching any brake fluid.

  2. Slide a new copper washer on each side of the hose fitting.

  3. Finger-start the titanium bolt and make sure the threads glide smoothly.

  4. Torque to 20 – 25 N·m (15 – 18 lb-ft) or follow your bike’s manual.

  5. Pump the lever, check for leaks, and safety-wire if you’re racing.

FAQs

Do I need thread sealant or anti-seize?
Kind of. You should use anti-seize if installing into aluminum, make sure the anti-seize is copper or nickel based. You should not use thread locker on titanium hardware

Can I reuse the washers?
Best practice is to replace them every time you remove the bolt.

Will this fit a Brembo RCS master cylinder?
Brembo uses fine-thread M10 × 1.0. Grab our M10 × 1.0 titanium banjo bolt instead.

Ships From USA!

View full details

Please be aware that many electric bikes sold by RegenRides, its partners, and wholesalers are intended exclusively for off-road use at their speed and power factory setting. Bypassing or modifying the bike restrictions does not adhere to proper use and as the owner, you will assume full responsibility and liability. It is important to acknowledge that these vehicles may not adhere to specific national, federal, provincial, and/or local laws or regulations.

As the buyer, it is your responsibility to thoroughly acquaint yourself with any potential restrictions that may apply to the usage of such a product in your specific location. You assume complete liability for the choices you make regarding its utilization and any potential ramifications that may arise as a result.

This vehicle is not an "electric assisted bicycle" as defined by North Carolina Motor Vehicle Code and is instead a type of motor vehicle and subject to applicable motor vehicle laws if used on public roads or public lands. Your insurance policies may not provide coverage for accidents involving the use of this vehicle. To determine if coverage is provided you should contact your insurance company or agent.